During the ride into Phnom Penh we ran over a particularly large bump and the cross bar of the right side of our front rack broke cleanly off.
We were able to do a good temporary fixing job with 2 large cable ties (well worth taping a stash of these to your frame along with your spare spokes) and some gaffa tape.
We had had concerns about the front frame for a while; the make is Avenir and its made of aluminium meaning its a lot harder to weld back together. Our back frame is solid steel.
To add insult to injury, just before heading off to seek out a bike shop we managed to shear the bolt inside the frame – now we had two things to fix…
Phnom Penh has a few bike shops near where we are staying (close to the Royal Palace).
The Giant Bike store near the Olympic stadium is the best store we found. The multi-storey store has an excellent range of new bikes, spare parts, helmets, tools, electronics, tyres, Degreaser etc. The clothes are very expensive though and they don’t stock much for women and we couldn’t find a front rack.
Flying Bikes (mainly a workshop) and its counterpart store down the road, Flying Bikes 2, have a range of mountain bikes as well as a fairly good collection of accessories – if you’re in need of a new helmet, clips, gloves etc. Again, they don’t stock women’s clothes so if your female don’t get your hopes up. They didn’t have any front racks either.
There is also Vicious Cycles on street 144 who run cycle tours – the guys there have a small workshop, speak good English and could probably help cyclists with minor problems such as broken cables and spokes but they were unable to help us with the bolt and told us that it was unlikely that we would find a new front rack in Phnom Penh, apparently you can’t get them here.
It became clear that what we needed was a good garage and mechanic followed by a welder who could work with aluminium.
SUCCESS! After enlisting the help of a very helpful tuk tuk driver to translate, one of the guys at the main garage extracted the bolt (by simply tapping a groove into the bolt end to screwdriver it out) from the frame in about two minutes and Paddy was pulled onto the back of a motorbike and taken up the road to a guy who could weld the aluminium. The whole thing cost
If this happens to you, wherever you are, be sure to have your rack on the other side reinforced at the same time (even if it doesn’t seem to need it). If one side has broken, the other side is sure to follow – this is what happened to us on the road to Seam Reap and we had to go through the same process all over again in a different town!